2011 Chevrolet Traverse Owner's Manual - Page 82
2011 Chevrolet Traverse Manual
Page 82 highlights
3-26 Seats and Restraints It may be necessary to pull the stitching on the safety belt through the latch plate to fully tighten the lap belt on smaller occupants. Before a door is closed, be sure the safety belt is out of the way. If a door is slammed against a safety belt, damage can occur to both the safety belt and the vehicle. Position the release button on the buckle so that the safety belt could be quickly unbuckled if necessary. 5. If equipped with a shoulder belt height adjuster, move it to the height that is right for you. See "Shoulder Belt Height Adjuster" later in this section for instructions on use and important safety information. Shoulder Belt Height Adjuster The vehicle has a shoulder belt height adjuster for the driver and right front passenger seating positions. Adjust the height so the shoulder portion of the belt is on the shoulder but not falling off of it. The belt should be close to but not contacting the neck. Improper shoulder belt height adjustment could reduce the effectiveness of the safety belt in a crash. See How to Wear Safety Belts Properly on page 3‑19. 6. To make the lap part tight, pull up on the shoulder belt. To unlatch the belt, push the button on the buckle. The belt should return to its stowed position. Slide the latch plate up the safety belt webbing when the safety belt is not in use. The latch plate should rest on the stitching on the safety belt, near the guide loop on the side wall.