2005 Chrysler Crossfire Owner's Manual - Page 103
2005 Chrysler Crossfire Manual
Page 103 highlights
UNDERSTANDING YOUR INSTRUMENT PANEL 103 The warning light should be checked frequently to assure that it is operating properly. This can be done by turning the ignition switch to START. The light should come on. If the red brake light does not come on when the ignition is turned to the ON/RUN position, have the brake light repaired promptly. WARNING! Driving a vehicle with the brake light on is dangerous. Part of the brake system may have failed. It will take longer to stop the vehicle. You could have an accident. Have the vehicle checked immediately. NOTE: This light shows only that the parking brake is on. It does not show the degree of brake application. The brake warning light will come on if the ABS light is not functioning and there is an ABS system malfunction. 11. Light Outage Indicator With the key in the ignition switch turned to the ON/RUN position, an indicator light comes on. It should go out when the engine is running. If the indicator light does not go out after starting the engine, or if it comes on while driving, it indicates a failure in the parking light, taillight, stoplight, or low beam headlight. The indicator light will come on when the exterior light fails. If a brake light fails, the light outage indicator will come on when applying the brake and stays on until the engine is turned off. NOTE: If additional lighting equipment is installed (e.g., auxiliary headlights, etc.) be certain to connect into the fuse before the failure indicator monitoring unit in order to avoid damaging the system. 12. Antilock Warning Indicator Light The ABS warning indicator light comes on with the key in the ignition switch turned to the ON/RUN position, and should go out with the engine running. 4