2006 Chrysler Sebring Owner's Manual - Page 20

20 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 2. Using a currently programmed transmitter, press the Unlock button on the transmitter. Continue to hold the Unlock button, wait at least 4 but no longer than 10 seconds, then press and hold the Panic button for at least one second. Release both buttons simultaneously. You will hear a chime to signal that you can proceed with programming the new transmitter. 3. Press and release the Lock and Unlock buttons simultaneously, followed by a press and release of ANY button on each new transmitter to be programmed as well as the original transmitter. You will hear a chime when a transmitter has been successfully programmed. You will have 30 seconds to finish programming all new transmitters. A chime will sound when the 30 seconds is over or the ignition switch is turned to the LOCK position. General Information This transmitter complies with FCC rules part 15 and with RS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference 2. This device must accept any interference that may be received, including interference that may cause undesired operation If your Remote Lock Control fails to operate from a normal distance, check for these two conditions: 1. Weak batteries in transmitter. The expected life of batteries is from one to two years 2. Closeness to a radio transmitter such as a radio station tower, airport transmitter, and some mobile or CB radios.