2006 Chrysler Sebring Owner's Manual - Page 240
2006 Chrysler Sebring Manual
Page 240 highlights
240 MAINTAINING YOUR VEHICLE • If the fluid is hot (180°F / 82°C), the reading should be in the cross hatched area marked "HOT" (between the upper two holes in the dipstick). • If the fluid level shows low, add sufficient transmission fluid to bring to the proper level. • Police, taxi, limousine, commercial type operation, or trailer towing where the vehicle is driven regularly for more than 45 minutes of continuous operation. NOTE: Refer to Section 8 of this manual for maintenance schedules. If the transaxle is disassembled for any reason, the fluid and filter should be changed. Special Additives The manufacture strongly recommends against the addition of any additives to the transaxle. The only exception to this policy is the use of special dyes to aid in detecting fluid leaks. The use of transmission sealers should be avoided as they may adversely affect seals. Fluid Level Check Check the fluid level by removing the fill plug. The fluid level should be between the bottom of the fill hole and a point not more than 4.0 mm below the bottom of the hole. Add fluid, if necessary, to maintain the proper level. Frequency of Fluid Change Under normal operating conditions, the fluid installed at the factory will give satisfactory lubrication for the life of CAUTION! Do not overfill. Dirt and water in the transaxle can cause serious damage. To prevent dirt and water from entering the transaxle after checking or replenishing fluid, make certain that the dipstick cap is seated properly. Fluid and Filter Changes Automatic transmission fluid and filter should be changed as follows: Maintenance schedule "A" - No change necessary. Maintenance schedule "B" - Every 60,000 miles (96 000 km) change fluid and filter under the following conditions: