2007 Chrysler Aspen Owner's Manual - Page 29
2007 Chrysler Aspen Manual
Page 29 highlights
THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 29 3. Place the key into the ignition. 4. Within 10 seconds, cycle the key from the OFF position to the ON position a minimum of four times; ending in the ON position. (do not start the engine). 5. Within 30 seconds, press the driver's door lock switch in the LOCK direction. 6. A single chime will be heard to indicate the feature has been disabled. 7. To re-activate this feature, repeat the above steps. 8. If a chime is not heard, program mode was canceled before the feature could be disabled. If necessary, repeat the above procedure. Auto Unlock On Exit - If Equipped This feature unlocks all of the doors of the vehicle when any door is opened (excluding the liftgate). This will occur only after the vehicle has been shifted into the Park position after the vehicle has been driven (shifted out of Park and all doors closed). This feature will not operate if there is any manual operation of the power door locks (Lock or Unlock). Auto Unlock On Exit Programming - If Equipped Customer Programming sequence to enable or disable the Auto Unlock Feature: 1. Enter your vehicle and close all doors. 2. Fasten your seat belt (fastening the seat belt will cancel any chimes that may be confusing during this programming procedure). 3. Insert the key into the ignition. 4. Within 15 seconds, cycle the key from the OFF position to the ON position a minimum of four times ending in the ON position (do not start the engine). 2