2006 Dodge Ram 1500 Pickup Owner's Manual - Page 186
2006 Dodge Ram 1500 Pickup Manual
Page 186 highlights
186 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 3. Simultaneously press and hold both the HomeLink button that you want to train and the hand-held transmitter buttons. Do not release the buttons until step 4 has been completed. NOTE: Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted in the Gate Operator/Canadian Programming section. 4. The HomeLink indicator light will flash slowly and then rapidly after HomeLink successfully receives the frequency signal from the hand-held transmitter. Release both buttons after the indicator light changes from the slow to the rapid flash. 5. Press and hold the just trained HomeLink button and observe the indicator light. If the indicator light stays on constantly, programming is complete and your device should activate when the HomeLink button is pressed and released. NOTE: To program the remaining two HomeLink buttons, begin with Programming step two. Do not repeat step one. If the indicator light blinks rapidly for two seconds and then turns to a constant light, continue with Programming steps 6-8 to complete the programming of a rolling code equipped device (most commonly a garage door opener). 6. At the garage door opener receiver (motor-head unit) in the garage, locate the learn or smart button. This can usually be found where the hanging antenna wire is attached to the motor-head unit. 7. Firmly press and release the learn or smart button. (The name and color of the button may vary by manufacturer.) NOTE: There are 30 seconds in which to initiate step eight.