2007 Dodge Charger Owner's Manual - Page 111
2007 Dodge Charger Manual
Page 111 highlights
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 111 1. Press and hold the two outer HomeLink buttons. Release the buttons only when the EVIC displays "Channels Cleared" (after 20 seconds); however, do not hold the buttons for longer than 30 seconds. Do not repeat this step if programming a second or third hand-held transmitter to the remaining HomeLink buttons. 3. Simultaneously press and hold the HomeLink button (that you want to train) and the hand-held transmitter button. Do not release the buttons until Step 4 is complete. NOTE: Some gate operators and garage door openers may require you to replace this Programming Step 3 with procedures noted under Gate Operator/Canadian Programming. 4. The EVIC will display "Channel X Training" (where X is Channel 1, 2, or 3). Release both buttons after the EVIC displays "Channel X Trained." NOTE: If the EVIC displays "Did Not Train," repeat Steps 2-4. 5. Press and hold the just trained HomeLink button and observe the EVIC display. If the EVIC displays "Channel X Transmit" (where X is Channel 1, 2, or 3), then programming is complete, and your device should activate when the HomeLink button is pressed and released. NOTE: To program the remaining two HomeLink buttons, begin with Programming Step 2. Do not repeat Step 1. 3 HomeLink Buttons 2. Position the end of your hand-held transmitter 1-3 inches (3-8 cm) away from the HomeLink buttons.