2007 Dodge Charger Owner's Manual - Page 40

40 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE BeltAlert Programming The Enhanced Warning System (BeltAlert) can be enabled or disabled by your authorized dealer or by performing the following steps: NOTE: DaimlerChrysler does not recommend deactivating the Enhanced Warning System (BeltAlert). 1. With all doors closed, and the ignition switch in any position except ON or START, buckle the driver's seat belt. 2. Turn the ignition switch to the ON/ RUN position, but do not start the engine. Wait for the Seat Belt Reminder Light to turn off and then proceed to the next step. NOTE: You must perform the following steps within 60 seconds of turning the ignition switch to the ON/ RUN position. 3. Within 60 seconds of turning the ignition switch to the ON/ RUN position, unbuckle and then re-buckle the driver's seat belt at least three times within 10 seconds, ending with the seat belt buckled. NOTE: Watch for the Seat Belt Reminder Light to turn on while unbuckling the seat belt and turn off while re-buckling the seat belt. It may be necessary to retract the seat belt. 4. Turn the ignition switch to the LOCK position. A single chime will sound to signify that you have successfully completed the programming. The Enhanced Warning System (BeltAlert) can be reactivated by repeating this procedure. NOTE: When the Enhanced Warning System (BeltAlert) is deactivated, the Seat Belt Reminder Light will continue to illuminate as long as the driver's seat belt is unbuckled. Automatic Locking Mode - If Equipped In this mode, the shoulder belt is automatically prelocked. However, the belt will still retract to remove slack in the shoulder belt. Use The Automatic Locking Mode any time a child safety seat is installed in a seating position that has a seat belt with this feature. Seat belts that have the Automatic Locking Mode feature have a