2009 Dodge Journey Owner's Manual - Page 168

166 UNDERSTANDING THE FEATURES OF YOUR VEHICLE NOTE: • Some gate operators and garage door openers may require you to replace Step 3 with procedures noted in the "Gate Operator/Canadian Programming" section. • After training a HomeLink channel, if the garage door does not operate with HomeLink and the garage door opener was manufactured after 1995, the garage door opener may have a rolling code. If so, proceed to the heading "Programming A Rolling Code System." 4. Press and hold the just-trained HomeLink and observe the indicator light. button If the indicator light blinks rapidly for two seconds, and then turns to a constant light, continue with programming for a Rolling Code. 5. PROGRAMMING A ROLLING CODE SYSTEM At the garage door opener motor (in the garage), locate the "Learn" or "Training" button. This can usually be found where the hanging antenna wire is attached to the garage door opener motor (it is NOT the button normally used to open and close the door). If the indicator light stays on constantly, programming is complete and the garage door (or device) should activate when the HomeLink button is pressed.