1997 Ford Contour Owner's Manual - Page 162
1997 Ford Contour Manual
Page 162 highlights
RWARNING If the vehicle slips off the jack, you or someone else could be seriously injured. 2. Get out the spare tire and jack. RWARNING To avoid injury, never run the engine with one wheel off the ground, such as when changing a tire. 3. Remove the wheel cover from the wheel with the tapered end of the wheel lug wrench. Insert and twist the handle, then pry against the inner wheel cover flange. For information about removing optional wheel center ornaments see Styled Polycast Wheel Ornaments later in this section. 4. Loosen the wheel lug nuts by pulling up on the handle of the wrench one-half turn counterclockwise. Do not remove the wheel lug nuts until you raise the tire off the ground. For information about removing anti-theft lug nuts, see Anti-Theft Wheel Lug Nuts later in this section. Removing and Replacing the Tire 1. Place the scissors-type jack under the side of the vehicle and adjust the jack height with the jack handle. The jack should fit in the notch in the vertical rocker panel flange which is nearest to the wheel to be changed. The front and rear jacking notches on each side of the vehicle are marked by arrows in the rocker panel. On sport models with "skirts," you must remove a portion of the skirt before placing the jack under the vehicle. Squeeze the removeable portion of the skirt and pull down. A tether connects it to the rocker panel. 164