2000 Ford Expedition Owner's Manual - Page 102

Seating and safety restraints Installing the third row seat Always latch the vehicle seat to the floor, whether the seat is occupied or empty. If not latched, the seat may cause injury during a sudden stop. When reinstalling a rear seat in your vehicle it must be placed in its original position. Improper installation of the seat will prevent correct use of the safety belts and could increase the risk of injury. Refer to the warning label on the seat belt. Before installing your third row seat, ensure that the detachable anchor tongues are stowed into the floor and the loose belts are stored out of the way. For proper latching, ensure that the floor tubs are clear of debris. From the rear of the vehicle, with the liftgate open: 1. With assistance, lift the seat into the rear of the vehicle and position front rollers onto the track. By rolling the seat forward, guide the seat positioners over the front pins of the floor tubs. 2. Guide the positioners around each pin and lower the seat. • When the rear of the seat is 10-13 cm (4-5 in) above the rear pins, let the seat drop. This will ensure that the seat will properly latch into the floor. 3. Locate the seat belt anchor tongue in the plastic housing on the floor. 4. Disconnect the detachable anchor from its stowage location and connect it to the anchor tongue (making sure that the label on the detachable anchor is pointing toward the outside of the vehicle (left side) and that the belts are not twisted or jammed). 5. Insert the seat detachable anchor into detachable anchor tongue until you hear a "click" and feel the latch engage. 6. Push up on the seat to verify that it is latched into the floor. 7. Verify that the safety belts can move freely on either side of the seat. 102