2004 Ford Freestar Owner's Manual - Page 62
2004 Ford Freestar Manual
Page 62 highlights
Driver Controls Resetting the PSD The power sliding door may operate incorrectly or not at all because of the following conditions: • a low voltage or dead battery • the door is left opened for more than 6 hours • the battery is disconnected • the PSD Passenger compartment fuse panel fuse (fuse #11) is removed or blown. Refer to Fuses and relays in the Roadside Emergencies chapter. If any of the above conditions has occurred, perform the following steps to reset the PSD so that electronics can relearn the open and closed positions: 1. Check to see if PSD is securely closed. 2. Make sure the gearshift is in (P) Park. 3. Push the PSD control on the overhead console to open the door. 4. Wait five (5) seconds and close the door by pressing the PSD control on the overhead console. 5. Wait five (5) seconds and repeat Steps 3 and 4 then go on to step 6. 6. Repeat steps 3-5 for opposite door. If the door still does not operate correctly: 7. Ensure the ignition is in the OFF position 8. Remove the PSD fuse (fuse #11) from the passenger fuse panel and leave it out for thirty (30) seconds. Refer to the chapter on Fuses and Relays. Refer to Fuses and relays in the Roadside emergencies chapter. 9. Reinstall the fuse and wait ten (10) seconds. 10. Repeat steps 1-6 above. If the door still does not operate correctly, see your dealer for service. Sliding Door Child Safety Lock Your vehicle is equipped with a sliding door child safety lock that helps prevent passengers from operating the sliding door by using the inside door handle, refer to the Child safety locks section in this chapter. 62 2004 Freestar (win) Owners Guide (post-2002-fmt) USA English (fus)