2005 Ford Expedition Owner's Manual - Page 110

Lights 3. Remove the two headlamp assembly retainer bolts and lamp assembly from the vehicle. 4. Loosen the vertical bolt on the backside of the headlamp assembly. Do not remove it. 5. Slide headlamp assembly forward and off of guide ribs to expose the back of the bulb and wiring connector. 6. Rotate the bulb socket counterclockwise and remove from the lamp assembly. 7. Carefully pull the bulb out of the socket and push in the new bulb. 8. Install the bulb socket into the lamp assembly and rotate clockwise. 9. Replace the lamp assembly and install all three retainer bolts on the lamp assembly. Replacing tail/stop/turn/sidemarker/backup lamp bulbs The tail/stop/turn/sidemarker/backup lamp bulbs are located in the same portion of the tail lamp assembly, one just below the other. Follow the same steps to replace either bulb: 1. Make sure the headlamp switch is in the OFF position and then open the liftgate to expose the lamp assembly screws. 2. Remove the two screws from the lamp assembly. 3. Carefully remove the lamp assembly away from the vehicle by pulling the assembly straight out to expose the bulb socket. DO NOT TIP THE LAMP ASSEMBLY SIDEWAYS. 4. Rotate the bulb socket counterclockwise and remove from lamp assembly. 5. Pull bulb straight out of socket and snap in the new bulb. 110 2005 Expedition (exd) Owners Guide (post-2002-fmt) USA (fus)