2005 Ford Expedition Owner's Manual - Page 113

Lights Approach lamp/mirror turn signal bulb removal (if equipped) To change the bulbs: 1. Make sure the headlamp switch is in the OFF position and then fold the mirror forward. 2. Remove the torx screw on the bottom of the turn signal lens using a T-10 torx driver. 3. Pull the turn signal lens down to remove it from the mirror assembly. 4. Disconnect the bulb assembly from the lens. 5. Remove and replace the bulb. 6. Reverse the order to reassemble lamp and lens. Approach lamp bulb removal (if equipped) To change the bulbs: 1. Make sure that all the doors are closed and the interior lights have automatically turned off or the opposite mirror approach lamp has turned off. 2. With a small flat tipped screwdriver, insert the tip into the approach light module slot located on the outboard corner of the lens to release the clip. 3. While holding the clip in the release position, pull the approach light module down. 4. Remove the two wires from the module and replace the module with a new one. 5. Reverse the order to reassemble the approach light module. 113 2005 Expedition (exd) Owners Guide (post-2002-fmt) USA (fus)