2006 Ford Fusion Owner's Manual - Page 44

Lights Handle a halogen headlamp bulb carefully and keep out of children's reach. Grasp the bulb only by its plastic base and do not touch the glass. The oil from your hand could cause the bulb to break the next time the headlamps are operated. 12. After the new bulb is installed, carefully let the bulb socket dangle downward near the lamp housing (Passenger side only with ABS). 13. From the exterior wheel well area reach arm through splash shield opening to install bulb socket with new bulb (Passenger side only with ABS). 14. Install the new bulb socket into the lamp assembly by aligning the indexing fingers, then rotate clockwise to locked position. 15. Install the protective rubber cap to the housing circular ring by pushing and pressing it forward. 16. Re-apply pressure around the complete circular ring on the housing to make sure the protective rubber cap is completely seated. 17. Reinstall splash shield access panel with screw (Passenger side only with ABS). 18. Reinstall the AirTube to the air filter assembly. (Driver's side only). 19. Reinstall the vertical shield to the bolster. (Driver's side only). 20. Turn the headlamps on and make sure they work properly. If the headlamp was correctly aligned before you changed the bulb, you should not need to align it again. Replacing front parking lamp/turn signal bulbs 1. Make sure headlamp switch is in the OFF position, then open the hood. 2. Reach over the front bolster. 44 2006 Fusion (fsn) Owners Guide (post-2002-fmt) USA (fus)