2007 Ford Explorer Quick Reference Guide 1st Printing

Essential Information

Location of Spare Tire and Tools:

The spare tire is located under the vehicle, just forward of the

rear bumper. The spare tire winch drive nut is located at the rear center of the cargo area, under

a lid. The jack, jack handle and lug nut wrench are located behind the rear seat, under the

carpeted lid in the cargo floor. The tools are contained in a bag attached to the jack.

Fuses:

If the vehicle’s electrical components are not operating, a fuse may have blown. The fuse

panel is located below the instrument panel on the driver’s side; remove the cover to view the

fuses. For more information regarding changing fuses, refer to the Roadside Emergencies

chapter of your Owner’s Guide.

Fuel Information:

Use regular unleaded gasoline with an (R+M)/2 octane rating of 87. Ford Motor

Company does not recommend using regular unleaded gasoline with an octane rating of 86 or

lower in high altitude areas. The advertised fuel capacity of the fuel tank is equal to the rated

refill capacity of the fuel tank as listed in the Maintenance and Specifications chapter of the

Owner’s Guide.

Tire Pressure:

Your vehicle’s tire pressure is properly set by your authorized dealer according to

the recommended specifications found on the vehicle’s tire label, located on the driver’s door

jamb. Check your tire pressure during routine maintenance and seasonal changes. If the Tire Pres-

sure Monitoring System light stays illuminated after starting, immediately check the vehicle’s tire

pressure.

Warning: Improperly inflated tires can affect vehicle handling and tire performance.

Fuel Pump Shut-Off Switch:

The fuel pump shut-off switch is a device intended to stop the

electric fuel pump when your vehicle has been involved in a substantial jolt. The switch is located

in the passenger’s footwell, by the kick panel. After a collision, if the engine cranks but does not

start, the fuel pump shut-off switch may have been activated. For more information regarding

the fuel pump shut-off switch, refer to the Roadside Emergencies chapter of your Owner’s Guide.

Changing the Tires:

The spare tire is not equipped with a Tire Pressure Monitoring System (TPMS)

sensor. The TPMS warning light will illuminate when the spare tire is in use. Replace the spare

tire with a road tire as soon as possible. If you get a flat tire while driving, do not apply the brake

heavily; instead, gradually decrease your speed, hold the steering wheel firmly and slowly move

to a safe place on the side of the road.

Roadside Assistance:

During your Explorer’s 3-year/36,000 mile limited warranty period, the

assurance and support of a 24-hour emergency roadside assistance program is included. Roadside

assistance includes such services as fuel delivery, tire changes, jump starts and help when you are

locked out of your vehicle. Complete your roadside assistance identification card and keep it handy

(such as in your wallet) for quick reference. This identification card is located in your Ford Owner’s

Information portfolio. To receive roadside assistance in the United States, call 1-800-241-3673.

Rear Window Buffeting:

When one or both of the rear windows are open, the vehicle may

demonstrate a wind throb or buffeting noise; this noise is common among a wide range of

vehicles and can be eliminated by simply lowering a front window approximately two to

three inches.

A. CD Eject:

Press and hold to

auto eject all CDs present in

the system. Press

and a

memory preset to eject from

a specific slot.

B. LOAD:

Press LOAD and

a memory preset to load to a

specific slot. Press and hold to

autoload up to six CDs.

C. Tune / Disc Selector:

Press

and release to manually advance

up / down the radio frequency or

to select a desired disc. Press and

hold for a fast advance through

radio frequencies or all loaded

discs. Also use in menu mode to

select various settings.

D. CD:

Press to enter CD mode.

If a CD is already loaded into

the system, CD play will begin

where it ended last. If no CD is

loaded, NO DISC will appear in

the display.

E. MUTE / Phone:

Press to mute

the playing media. Press again to

return to the playing media.

SATELLITE RADIO CONTROLS: (if

equipped)

F. AUX:

Press repeatedly to

cycle through SAT1, SAT2, SAT3

(satellite radio mode

if equipped),

LINE IN (auxiliary

audio mode), or

FES/DVD (if equipped). Once

Satellite Radio mode is activated

you may use the

following

functions:

Press MENU until CATEGORY

MODE appears in the

display.

Press

/

to select from various

categories

of music (country, rock,

etc.) and press and hold

SEEK

or TEXT/SCAN to search for chan-

nels playing that specific category

of music.

Press

SEEK

to access the

previous/next channels. Press and

release TEXT/SCAN to display the

current song title. Press again to

scroll through current song title,

artist, channel category and

the SIRIUS long channel name.

Press and hold for a brief sam-

pling of the next channels. Press

again to stop.

G. MENU:

Press repeatedly to

cycle through the following

modes: Autoset, Bass, Treble,

Balance, Fade, Occupancy mode,

Speed sensitive volume, Setting

the clock, RBDS (Radio Broadcast

Digital Signal), Track / Folder

Mode & Compression. For more

information on these menu items,

refer to your Owner’s Guide.

H. SEEK:

Press < to access the

previous strong station or track.

Press > to access the next strong

station or track.

I. TEXT / SCAN:

Press and hold

for a brief sampling of radio

stations or CD tracks. Press again

to stop. In CD / MP3 mode, press

TEXT to display track title, artist

name and disc title.

J. REW (Rewind):

Press to

manually reverse in a CD or

MP3 track.

K. FF (Fast Forward):

Press to

manually advance in a CD or

MP3 track.

L. FOLDER:

In folder mode, press

to access the previous or next

folder on MP3 discs, if available.

M. SHUFFLE:

Press to play the

tracks on the current disc in

random order.

N. PLAY / PAUSE:

This control is

operational in CD and DVD mode

(if equipped). When a CD or

DVD

is playing in the Family

Entertainment

System, press

this control to play or pause the

current CD / DVD. The CD / DVD

status will display in the

radio display.

O. Memory Presets:

To set a

station, select frequency band AM

/ FM1 / FM2 , tune to a station,

press and hold a preset button

(1-6) until sound returns.

*F7L2J-19G217-BA*

7L2J-19G217-BA

This Quick Reference Guide is not intended to replace your vehicle Owner’s Guide which

contains more detailed information concerning the features of your vehicle, as well as

important safety warnings designed to help reduce the risk of injury to you and your

passengers. Please read your entire Owner’s Guide carefully as you begin learning about

your new vehicle and refer to the appropriate sections when questions arise.

All information contained in this Quick Reference Guide was accurate at the time of

duplication. We reserve the right to change features, operation and/or functionality of

any vehicle specification at any time. Your Ford dealer is the best source for the most

current information. For detailed operating and safety information, please refer to

your Owner’s Guide.

Ford Motor Company

Customer Relationship Center

P.O. Box 6248

Dearborn, MI 48121

1-800-392-3673 (FORD)

(TDD for the hearing impaired: 1-800-232-5952)

Additional Features

Remote Entry System

The remote entry system allows you to lock or unlock all vehicle

doors and the liftgate, open the liftgate window without a key,

and activate the panic alarm.

Press control

C

and release to unlock the driver’s door. Press

and release again within three seconds to unlock the passenger

doors, the liftgate and liftgate glass. Press control

A

and release

to lock all the doors and liftgate. Press control

D

to unlatch the

liftgate window. Press control

B

to activate the alarm. The horn

will sound and the parklamps will flash for a maximum of three

minutes. Press the control again or turn the ignition to the on

position to deactivate. The remote entry system can also control

the memory seat / adjustable pedals / easy entry-exit feature

(if equipped). Press the

C

control to automatically move the seat and adjustable pedals to the

desired memory position (if equipped) (the seat position corresponds to the transmitter being

used). For more information regarding the memory seats / adjustable pedals / easy entry-exit

feature, refer to your Owner’s Guide.

HomeLink® Wireless Control System

(if equipped)

The HomeLink® Wireless Control System, located on the overhead console,

provides a convenient way to replace up to three hand-held transmitters with a

single built-in device. This feature will learn the radio frequency codes of most

transmitters to operate garage doors, entry gate operators, security systems, entry

door locks, and home or office lighting. To set the HomeLink® Wireless Control

System, refer to your Owner’s Guide. To operate, simply press and release the

appropriate HomeLink® button. Activation will now occur for the trained product

(garage door, gate operator, security system, entry door lock, home or office lighting, etc.).

For convenience, the hand-held transmitter of the device may also be used at any time.

Navigation System

(if equipped)

Your vehicle may be equipped with a Navigation System. Refer to the Navigation Supplement for

further information on the operation of your system.

Family Entertainment System (FES)

(if equipped)

Your vehicle may be equipped with a Family Entertainment System (Rear seat DVD player with

wireless headphones and remote control). Refer to the Family Entertainment System Supplement

Guide for further information on the operation of your system.

Auxiliary Input Jack (AIJ)

Your vehicle is equipped with an Auxiliary Input Jack (AIJ) located inside the

console bin

(E)

. This allows you to plug

and play auxiliary audio devices. Press

AUX repeatedly on your audio system to access. When LINE IN appears in the

display, plug in your auxiliary audio device. For more detailed information,

please

refer to your Owner’s Guide.

Power Deployable Running Boards

(if equipped)

The deployable running boards automatically move when the doors are opened to assist with

entering and exiting the vehicle. With automatic power deploy, the running boards will extend

out when the doors are opened, and with automatic power stow, the running boards will return

to the stowed position when the doors are closed. To enable / disable the power running board

feature, refer to the Message Center section of your Owner’s Guide.

Seating

2nd Row Seats:

The second

row seats are designed for

maximum utility.

They can

be positioned in up to three

unique configurations:

Upright (seating) position,

Cargo mode, and E-Z entry

mode (if equipped with 3rd

row seat).

Before folding down the 2nd

row seats, ensure that no

objects such

as books,

purses, or

briefcases

are on the

floor in

front of or

under the seat.

1.

Lower the

head restraints by pulling on

the strap.

2.

Locate the handle

on the side of the seat cushion

by the door.

3.

Pull up on the

handle and push the seatback

forward toward the front of

the vehicle.

To place the 2nd row 60/40

seats in cargo mode:

(if equipped with a 3rd row

seat)

1.

Fold down the 2nd

row seat as

indicated.

2.

Pull the

cargo mode

lever up and

forward

to release

the seat

into a flat

load floor

position. A

moderate

force may

be required to move the seat

forward and down.

To return to the upright

(seating) position from cargo

mode:

1.

Place your hand

under the seat bottom and

lift the seat up (A moderate

force may be required to

move the seat).

2.

Return

the seatback to the upright

position.

Note:

The seatback

cannot be returned to the

upright position until the seat

is returned from the cargo

mode position and latched. If

the seatback will not raise,

re-position the seat into cargo

mode and try lifting it again.

To enter the 3rd row seat:

(if equipped)

1.

Fold the

seatback

down (as

indicated)

and release

the side

handle.

2.

Pull the

side handle up again until the

rear of the seat releases from

the floor.

3.

Rotate the seat

upward and away from the

3rd row.

To return the 2nd row seat to

the upright (seating) position

from E-Z entry mode:

1.

Return the seat from the

E-Z entry position and latch it

to the floor with a moderate

speed.

2.

Bring the seatback

to an upright position.

Note:

If the seatback will not return

to the upright position,

tumble the seat forward

again and then re-latch it

to the floor. Be sure that

cargo or other objects are not

trapped underneath

the seatback.

3rd Row Seats:

(if equipped)

Before folding the 3rd row

seats, ensure that no objects

such as books, purses or

briefcases are on the seat

cushions and that the seat

belts are unbuckled.

1.

Fold

the head restraints

down by

pulling on the strap located

under the restraint.

2.

Pull

up on the

handle

located

behind the

seatback

while

pushing the

seatback forward and down

into the seat cushion.

Note:

For 3rd row power folding

seat (if equipped), the control

buttons are located on the

driver-side rear quarter trim

panel (accessible from the

liftgate area). Be sure to fold

the head restraints before

powering the 3rd row seat

into the folded position.

To return the 3rd row seats to

the upright (seating)

position:

1.

Pull up on the

handle located on the

seatback, rotating the

seatback upward until you

hear a click, locking it in the

upright position.

2.

Lift up

on the head restraint until it

locks into its original position.

2007

EXPLORER

AUDIOPHILE AM / FM IN-DASH SIX CD / MP3 / SATELLITE COMPATIBLE SOUND SYSTEM

*

A.

B.

C.

D.

E.

F.

G.

I.

H.

J.

K.

L.

M.

N.

O.

*If equipped.

This vehicle handles differently from an ordinary passenger car in driving conditions which may occur

on streets and highways and off-road.

DRIVE WITH CARE AND WEAR A SAFETY BELT AT ALL TIMES.

Ford urges you to read the Owner’s Guide and Driving Your SUV or Truck Supplement for detailed

information on safe driving precautions and instructions.

H.

A.

B.

C.

D.

2007

EXPLORER

QUICK REFERENCE GUIDE

First Printing, June 2006

E.

2007 Ford Explorer Quick Reference Guide 1st Printing

2007 Ford Explorer Manual

2007 Ford Explorer manual content summary: