2008 Ford F450 Special Off-Road Package Supplement 1st Printing
2008 Ford F450 Manual
2008 Ford F450 manual content summary:
- 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 1
storage and retrieval system or translation in whole or part is not permitted without written authorization from Ford Motor Company. Ford may change the contents without notice and without incurring obligation. Copyright © 2006 Ford Motor Company 1 2008 F-250/350/450/550 (f23) Supplement - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 2
Privilege to exempt vehicles from full FMVSS compliance. When blackout lighting is enabled, it will turn off ALL interior and exterior lights (i.e.headlamps, stop lamps, backup lamps, interior warning lights, etc). Proceed with caution. 2 2008 F-250/350/450/550 (f23) Supplement USA (fus) - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 3
with fog lamps and reversing assist lamps in the front bumper. The fog lamps can be activated by using the switch located below the radio. The reversing assist lamps are automatically activated when the transmission is put into R (Reverse). 3 2008 F-250/350/450/550 (f23) Supplement USA (fus) - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 4
winch model designation. Part number - Identifies winch configuration. Date code - Identifies manufacture date. Serial number - Individually identifies winch. Winch basics Note: Never operate or install a winch without reading or understanding the instructions. 4 2008 F-250/350/450/550 (f23 - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 5
: Converts winch motor power into pulling force. 6. Braking system: Prevents winch from paying out line, which in turn holds the vehicle in place. The brake is automatically applied to the winch drum when the motor is stopped and there is load on the rope. 5 2008 F-250/350/450/550 (f23) Supplement - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 6
Controls 7. Clutch: Allows the operator to manually disengage the winch drum from the gear train, enabling the drum to freely rotate ("freespooling"). Engaging the clutch "locks" the winch drum back is being powered in. Winches can develop tremendous pulling pressure which can easily remove fingers - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 7
Driver Controls • Clevis/D-Shackle: The D-Shackle is a safe means for connecting the looped ends of cables and straps. The shackle's pin is threaded to allow easy removal. • Choker chains additional assistance is needed during winching activities. 7 2008 F-250/350/450/550 (f23) Supplement USA (fus) - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 8
Controls • Backup parts: Extra items such as an extra clevis/D-shackle or a remote control jumper cables in case your battery becomes drained during a winching operation. Also, a dual battery system and a battery isolator kit can be vehicle 8 2008 F-250/350/450/550 (f23) Supplement USA (fus) - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 9
controlling the winch can not see both hands of the navigator, the winch should not be activated. The following are some suggested hand signals to review: 1. Hold your arms out with thumbs up and tilt your hands in the direction you advise the driver to steer. 2. Hold your forefinger in the air - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 10
tension. Never engage the clutch while the drum is rotating. Always make sure the clutch is fully engaged or disengaged. Note: Never leave the remote control plugged into the winch while freespooling, rigging or sitting idle. 10 2008 F-250/350/450/550 (f23) Supplement USA (fus) - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 11
Driver Controls 3. Free the winch hook from its anchor point and attach the hook strap or chain and through the hook loop. Be careful not to overtighten (tighten, then back-off 1⁄2 turn). 7. Lock (Engage) the clutch using the lever on the winch. 11 2008 F-250/350/450/550 (f23) Supplement USA (fus) - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 12
control when not in use. 9. Slowly wind the wire rope until no slack remains by using the winch switch. Once the wire rope is under tension, stand clear and never step over it. 10. Check the anchor point. Make sure all connections the vehicle's engine on and light tension on As you power in, make - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 13
, be sure to secure the vehicle's brakes and put the transmission in P (Park) (automatic transmission) or 1 (First) (manual transmission). Release tension in the wire rope. 17. Disconnect the wire rope from the anchor. 18. Rewind the wire rope. Control the winch at all times and walk the rope in - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 14
wire rope under light tension and spool the wire rope back onto the the remote control switch. Store the hook at the fairlead or tensioned to a suitable location to the simply increasing pulling power or maintaining a may damage the wire rope. A snatch block, secured to a point directly in front - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 15
Controls Increasing pulling power Using snatch blocks increases the pulling power of your winch. Double line Pulling power decreases with the number of layers of rope on the drum; using a snatch block overtighten (tighten and back off 1⁄2 turn). 15 2008 F-250/350/450/550 (f23) Supplement USA (fus) - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 16
Keep winch, wire rope and switch control free from contaminants. Use a clean rag or towel to remove any dirt and debris. If necessary, unwind the winch completely (leaving a minimum of five wraps of rope on the drum) and wipe it clean before rewinding it. Using a light oil on the rope and winch hook - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 17
accessories that use more than 12 volts to be plugged into the vehicle without damaging the vehicle's electrical system. There are three connection points: Two on the rear bumper One on the instrument panel. To activate the converter, use the switch mounted on the instrument panel, below the radio - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 18
to the label on the back of the sun visor mirror regarding Anti-lock Brake System (ABS) operation. Your vehicle's Anti-lock Brake System (ABS) may be designed to deactivate when 4WD Low is engaged. The ABS indicator ( ABS ) illuminates and stays on, to indicate that ABS is deactivated, as long as - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 19
Driving Dual action remote control suspension (if equipped) To operate the system: 1. Push the red button to pressurize the system for a firmer ride. 2. Push the black buttons on the bleed valves for a softer ride. Separate bleed valves allow independent adjustment of front and rear shocks. Note: - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 20
of vehicle control. The vehicle's braking capacity is reduced when a turn is made while coasting downhill because the inside wheel is then disconnected from the driveline. Operating in low gear will allow the engine to act as a retarder and will improve braking capacity. 20 2008 F-250/350/450/550 - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 21
's instructions for adjustments to other components in the axle. SAND INGESTION When driving through sand, traction or brake capability may be limited. Also, sand may enter your engine's air intake and severely damage your engine or your vehicle may stall. Driving through sand where the transmission - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 22
. A compressor, mounted to the frame under the truck on the passenger side frame rail, is included along with an air reservoir on the driver side. When the compressor is on, the output pressure at the air tank is limited to 80 psi (552 kPa). 22 2008 F-250/350/450/550 (f23) Supplement USA (fus) - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 23
to work on the truck and prevent the condensation of water in the reservoir, extending the life of air system components. The air compressor inlet is equipped with a filter to prevent the ingestion of contamination into the compressor and air system. This filter is located underneath the truck, by - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 24
forget to re-install the cap on the valve stem. TIRE PRESSURE MONITORING SYSTEM (TPMS) (IF EQUIPPED) If your vehicle is equipped with a Tire Pressure Monitoring System (TPMS), refer to your Owner's Guide for complete details on system operation. 24 2008 F-250/350/450/550 (f23) Supplement USA (fus) - 2008 Ford F450 | Special Off-Road Package Supplement 1st Printing - Page 25
Refer to your Owner's Guide for the tire changing procedure. Follow the F-350 Dual Rear Wheel (DRW) jacking instructions. FUSING Note: Fuse 29 in the instrument panel box, located below and to the left of the steering wheel, should be a 15A mini fuse. Always replace the fuse you removed with a fuse
Lights
2
Driver Controls
4
Driving
18
Tires, Wheels and Loading
22
Roadside emergencies
25
All rights reserved. Reproduction by any means, electronic or mechanical
including photocopying, recording or by any information storage and retrieval
system or translation in whole or part is not permitted without written
authorization from Ford Motor Company. Ford may change the contents without
notice and without incurring obligation.
Copyright © 2006 Ford Motor Company
Table of Contents
1
2008 F-250/350/450/550
(f23)
Supplement
USA
(fus)