2011 Ford E250 Cargo Owner Guide 3rd Printing - Page 25

Instrument Cluster Compass zone adjustment 1. Determine which magnetic zone you are in for your geographic location by referring to the zone 15 3 2 1 map. 4 14 2. Press and release the 13 SELECT/RESET stem to scroll 5 through the information displays 12 until the message center displays HOLD RESET FOR SETUP MENU. 6 7 8 9 1011 3. Press and hold the SELECT/RESET stem to get into the setup menu. Repeatedly press it again to scroll through the setup menu until the message center displays COMPASS ZONE XX. 4. Press and hold the SELECT/RESET stem for approximately two seconds to go to the next zone, then release. 5. Press and hold to go up by one zone then release. Repeat this until you reach the desired zone. 6. Release the SELECT/RESET stem and allow the setup timer to expire to exit the procedure. Compass calibration adjustment Note: For optimum calibration, drive to an open, level location away from large metallic objects or structures. Switch off all non-essential electrical accessories (heated rear window, heater, A/C, map lamps, wiper, etc.) and make sure all the doors are closed. 1. Press and release the SELECT/RESET stem to scroll through the information displays until the message center displays HOLD RESET FOR SETUP MENU. 2. Press and hold the SELECT/RESET stem to get into the setup menu. Repeatedly press it again to scroll through the setup menu until the message center displays HOLD RESET FOR CALIBRATION. 3. Press and hold the SELECT/RESET stem for approximately two seconds until the message center enters the compass zone adjustment mode. 4. Press and hold the SELECT/RESET stem until the message center displays CIRCLE SLOWLY TO CALIBRATE. Note: This step may require up to five circles to complete the calibration. 25 2011 Econoline (eco) Owners Guide, 3rd Printing USA (fus)