2011 Ford E250 Cargo Owner Guide 3rd Printing - Page 80
2011 Ford E250 Cargo Manual
Page 80 highlights
Locks and Security Switching from two step to one step door unlocking Your vehicle comes with two step unlocking enabled. With the vehicle locked, unlocking can be switched between two step and one step door and buttons unlocking by pressing and holding both the simultaneously on the remote entry transmitter for approximately four seconds and release. The park lamps will flash twice to indicate that the vehicle has switched to one step unlocking. Repeat the procedure to switch back to two-step unlocking. Locking the doors 1. Press and release to lock all the doors. If all doors are closed the parking lamps illuminate. and release again within three seconds to confirm that all 2. Press the doors are closed and locked. Note: The doors will lock again, the turn lamps will flash and the horn will chirp once. If any door is ajar the lamps will not flash and the horn will chirp twice. Car finder twice within three seconds. The horn will chirp and the turn Press lamps will flash. It is recommended that this method be used to locate your vehicle, rather than using the panic alarm. Sounding a panic alarm to activate the alarm. Press the control again, or turn the Press ignition to the accessory or on position to deactivate the alarm. Note: The panic alarm will operate regardless of the ignition position. Replacing the battery The remote entry transmitter uses one coin type three-volt lithium battery CR2032 or equivalent. 80 2011 Econoline (eco) Owners Guide, 3rd Printing USA (fus)