2011 Ford F450 Super Duty Crew Cab Diesel Supplement 5th Printing - Page 87

2011 Ford F450 Super Duty Crew Cab Manual

Get 2011 Ford F450 Super Duty Crew Cab PDF manuals and user guides View all 2011 Ford F450 Super Duty Crew Cab manuals

Page 87 highlights

Scheduled Maintenance Guide Off-road operation As required - Inspect steering and suspension ball joints and tie rods; lubricate if equipped with grease fittings - Inspect functional holes in each leg of the twin tip and the holes under the shield just inboard of the right rear tire to make sure they are kept clean/clear of debris or foreign materials. Refer to the Cleaning chapter for more information Every 7,500 miles (12,000 km) - Inspect air filter restriction gauge; replace filter as indicated by gauge - Rotate tires, inspect tires for wear and measure tread depth and inspect wheel ends for endplay and noise; dual rear wheels should only be rotated if unusual wear is observed - Inspect brake system pads and rotors Every 7,500 miles (12,000 km) or - Change engine oil and filter 300 engine hours - Inspect and lubricate U-joints Every 15,000 miles (24,000 km), - Replace engine- and frame-mounted fuel filters 6 months, 600 engine hours or as indicated by message center Every 30,000 miles (48,000 km) - Replace wheel bearing grease/grease seals if nonsealed bearings are used (2WD vehicles) Every 50,000 miles (80,000 km) - Change rear axle fluid (if equipped with a Dana rear axle; some F-350s, all F-450/550s) - Change transfer case fluid (4WD vehicles) - Inspect front axle fluid (4WD vehicles) Reset your Intelligent Oil Life Monitor™ after each engine oil and filter change; refer to the Instrument Cluster chapter of the Owner's Guide. 87 2011 Diesel (eco) Supplement, 5th Printing USA (fus)

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
Off-road operation
As required
– Inspect steering and suspension ball joints and tie rods;
lubricate if equipped with grease fittings
– Inspect functional holes in each leg of the twin tip and
the holes under the shield just inboard of the right rear
tire to make sure they are kept clean/clear of debris or
foreign materials. Refer to the
Cleaning
chapter for more
information
Every 7,500 miles (12,000 km)
– Inspect air filter restriction gauge; replace filter as
indicated by gauge
– Rotate tires, inspect tires for wear and measure tread
depth and inspect wheel ends for endplay and noise; dual
rear wheels should only be rotated if unusual wear is
observed
– Inspect brake system pads and rotors
Every 7,500 miles (12,000 km) or
300 engine hours
– Change engine oil and filter
– Inspect and lubricate U-joints
Every 15,000 miles (24,000 km),
6 months, 600 engine hours or as
indicated by message center
– Replace engine- and frame-mounted fuel filters
Every 30,000 miles (48,000 km)
– Replace wheel bearing grease/grease seals if non-
sealed bearings are used (2WD vehicles)
Every 50,000 miles (80,000 km)
– Change rear axle fluid (if equipped with a Dana rear
axle; some F-350s, all F-450/550s)
– Change transfer case fluid (4WD vehicles)
– Inspect front axle fluid (4WD vehicles)
Reset your Intelligent Oil Life Monitor™ after each engine oil and filter
change; refer to the
Instrument Cluster
chapter of the
Owner’s Guide.
Scheduled Maintenance Guide
87
2011 Diesel
(eco)
Supplement, 5th Printing
USA
(fus)