1996 GMC Jimmy Owner's Manual - Page 141

Finding a Station TUNE-AM-FM: Turn this knob to tune in radio stations. Press it to switch between AM and FM. In addition to the four stations set as above, up to three additional stations may be preset on each band by pressing two adjoining buttons at the same time. Just: 1. Tune in the desired station. SEEK: Press this button to go to the next higher station and stop. 2. Press SET. (SET will appear on the display.) 3. Press two adjoining pushbuttons at the same time, within five seconds. Whenever you press the same two buttons, the station you set will return. SCAN: Press this button to listen to each station for a few seconds. The radio will go to the next station, stop for afew seconds, then go to the next station. SCAN will appear on the display. Press SCAN again to stop scanning. PUSHBUTTONS: The four numbered pushbuttons let you return to your favorite stations. You can set up to 14 stations (seven AM and seven FM). 1. Tune in the desired station. 4. Repeat these steps for each pair of buttons. Setting the Tone BASS: Slide this lever up to increase the bass. Adjust the lever until the sound is pleasing to your ear. TREBLE: Slide this lever up to increase the treble. You can reduce noise for weak or noisy stations by sliding this lever down. Adjusting the Speakers 2. Press SET. (SET will appear on the display.) 3. Press one of the four pushbuttons, within five seconds, to store the station. Whenever you press that numbered button, the station you set will return. 4. Repeat the steps for each pushbutton. BAL: This control ring behind the PWR-VOL-PROG-RCL knob adjusts the balance between left and right speakers. the 3-8