2003 GMC Yukon Owner's Manual - Page 441

To store the tools, follow these procedures: For Tahoe/Yukon, do the following: 1. Put the tool kit, with the jack tools and gloves, in the tool bag and place in the retaining clip above the jack. 2. Tighten down with the wing nut. 3. Then, assemble wheel chocks and bottle jack together with the wing nut and retaining hook. 4. Position behind the jack storage cover in the left rear side panel and tighten, adjusting clockwise until the jack is secured tight in the mounting bracket. Be sure to position the holes in the base of the jack onto the pin in the mounting bracket. For Suburban/Yukon XLdo the following: 1. Return the tool kit (jack tools and gloves) to the tool bag. 2. Assemble wheel chocks and bottle jack together with the wing nut and retaining hook. 3. Position under the jack storage tray in the left rear side panel below the wheelbase and tighten, adjusting clockwise until the jack is secured tight in the mounting bracket. Be sure to position the holes in the base of the jack onto the pin in the mounting bracket. 4. Use the retaining clip to fasten the tool kit on the stud in the storage compartment in the rear left trim panel and turn the wing nut clockwise to secure. 5. Return the storage tray. Tahoe/Yukon (Rear Access Panel) C. Wing Nut Holding A. Tool Kit with Jack Tire Block Tools and Gloves D. Tire Blocks B. Retaining Bracket E. Bottle Jack and Wing Nut 5-83