2004 GMC Sierra 1500 Pickup Owner's Manual - Page 164

To store your memory seat, mirrors and radio presets, do the following: 1. Adjust the driver's seat, including the seatback recliner, lumbar, and side wing area, both of the outside mirrors, and the radio station presets to your preference. 2. Press and hold the 1 or 2 button of the memory control for three seconds, to correspond to driver 1 or 2. A double chime will sound to let you know that the position has been stored. To repeat the procedure for a second driver, follow the preceding steps, but press the other numbered memory control button. Each time button 1 or 2 is pressed and released while the vehicle is in PARK (P), a single chime will sound and the memory position will be recalled. If you use the unlock button on the remote keyless entry transmitter to enter your vehicle, the preset driver's seat, mirror positions and the radio station presets will be recalled if programmed to do so through the Driver Information Center (DIC). See Driver Information Center (DIC) on page 3-55. The numbers on the back of the transmitters, 1 or 2, correspond to the numbers on the memory controls. The seat and mirror positions can also be recalled when placing the key in the ignition if programmed to do so through the Driver Information Center (DIC). 2-70 To stop recall movement of the memory seat feature at any time, press one of the memory buttons or power seat controls. Easy Exit Seat The controls for this memory function are located on the driver's door. B This button is used to program and recall the desired driver's seat position when exiting/entering the vehicle. The seat position can be personalized for both driver 1 and driver 2. To store the seat exit position for driver 1 or 2, do the following: 1. Select the desired driver number by pressing and releasing the 1 or 2 button. The seat will move to the stored memory position. 2. Adjust the seat to the desired exit position. 3. Press and hold the exit button of the memory control for three seconds. A double chime will sound to let you know that the position has been stored for the identified driver, 1 or 2. To use the seat exit position, do one of the following: • Press the exit button on the memory control. • If this feature is has been enabled in the DIC, removing the key from the ignition will cause the seat to move to the exit position.