2010 GMC Acadia Owner's Manual - Page 240

7-52 Infotainment System . Making a Call Calls can be made using the following commands: ... Dial Digit Dial Call Re‐dial Using the Dial Command 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. Say "Dial". The system responds with "Dial using ". "Number please" followed by a tone. 3. Say the entire number without pausing. . If the system does not recognize the number, it confirms the numbers followed by a tone. If the number is correct, say "Yes". The system responds with "OK, Dialing" and dials the number. If the number is not correct, say "No". The system will ask for the number to be re‐entered. 4. Continue entering digits until the number to be dialed is complete. After the whole number has been entered, say "Dial". The system responds with "OK, Dialing" and dials the number. . If an unwanted number is recognized by the system, say "Clear" at any time to clear the last number. To hear all of the numbers recognized by the system, say "Verify" at any time and the system will repeat them. Using the Digit Dial Command 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. Say "Digit Dial". The system responds with "Digit dial using , please say the first digit to dial" followed by a tone. 3. Say the digit to be dialed one at a time. Following each digit, the system will repeat back the digit it heard followed by a tone. . Using the Call Command 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. Say "Call". The system responds with "Call using . Please say the name tag" followed by a tone. If the system recognizes the number, it responds with "OK, Dialing" and dials the number.