2010 Honda CR-V Owner's Manual - Page 118

09/07/16 18:03:53 31SWA630_117 Power Windows DRIVER'S WINDOW SWITCH Closing a power window on someone's hands or fingers can cause serious injury. Make sure your passengers are away from the windows before closing them. MAIN SWITCH have children in the vehicle so they do not injure themselves by operating the windows unintentionally. AUTO REVERSE If the driver's window senses any obstacle while it is closing automatically, it will reverse direction, and then stop. To close the window, remove the obstacle, then use the window switch again. Auto reverse stops sensing when the window is almost closed. You should always check that all passengers and objects are away from the window before closing it. NOTE: The driver's window auto reverse function is disabled when you continuously pull up the switch. Turn the ignition switch to the ON (II) position to raise or lower any window. To open the window, push the switch down and hold it. Release the switch when you want to stop the window. To close the window, pull back on the switch and hold it. The windows will operate for up to 10 minutes after you turn off the ignition switch. Opening either front door cancels this function. AUTO To open or close the driver's window, push or pull the window switch firmly down or up to the second detent, and release it. The window will automatically go up or down all the way. To stop the window, pull or push the window switch briefly. When you push the MAIN switch in, the switch is off, and the passenger windows cannot be raised or lowered. To cancel this feature, push on the switch again to get it to pop out. Keep the MAIN switch off when you 112