2010 Honda CR-V Owner's Manual - Page 164
2010 Honda CR-V Manual
Page 164 highlights
09/07/16 18:11:41 31SWA630_163 Playing the FM/AM Radio (EX and EX-L models without navigation system) To Play the FM/AM Radio The ignition switch must be in the ACCESSORY (I) or ON (II) position. Turn the system on by pushing the FM or AM button. Adjust the volume by turning the VOL/SELECT knob. The band and frequency that the radio was last tuned to are displayed. To change bands, press the AM or FM button. On the FM band, ST will be displayed if the station is broadcasting in stereo. Stereo reproduction in AM is not available. To Select a Station You can use any of five methods to find radio stations on the selected band: tune, seek, scan, the preset buttons, and auto select. TUNE Use the SEEK button to tune to a desired frequency. Press the button to tune to a higher frequency, and the button to tune to a lower frequency. You can also operate the tune function by using the VOL/SELECT knob. Press the VOL/SELECT knob and you will see ''SEL'' in the display. Turn the knob right to tune to a higher frequency, or left to tune to a lower frequency. To turn it off, press the VOL/SELECT knob or button, or button. The system will return to the normal display about 10 seconds after you stop adjusting the tune mode. The SEEK function SEEK searches up and down from the current frequency to find a station with a strong signal. To activate it, press and hold the or side of the SEEK button until you hear a beep, then release it. SCAN The scan function samples all stations with strong signals on the selected band. To activate it, press the SCAN button, then release it. You will see SCAN in the display. When the system finds a strong signal, it will stop and play that station for about 10 seconds. If you do nothing, the system will then scan for the next strong station and play it for 10 seconds. When it plays a station you want to listen to, press the SCAN button again. 158