2010 Honda CR-V Owner's Manual - Page 366
2010 Honda CR-V Manual
Page 366 highlights
09/07/16 18:47:58 31SWA630_365 Lights 5. Install the new bulb into the hole, making sure the tabs are in their slots. Pivot the hold-down wire back in place, and clip the end into the slot. 6. Install the rubber seal over the back of the headlight assembly. Make sure one of the three arrows on the rubber seal is facing up; it is marked CONNECTOR BULB WEATHER SEAL 2. Remove the electrical connector from the bulb by pulling the connector straight back. 3. Remove the rubber weather seal by pulling on the tab. 4. Unclip the end of the hold-down wire from its slot. Pivot it out of the way, and remove the bulb. 7. Push the electrical connector onto the new bulb. Make sure it is connected securely. Turn on the headlights to test the new bulb. 8. (Driver's side) Reinstall the under-hood fuse box. 360