2010 Honda Insight Owner's Manual - Page 410

Fuses Checking and Replacing Fuses If something electrical in your vehicle stops working, the first thing you should check for is a blown fuse. Determine from the chart on pages 410 and 411 , or the diagram on the fuse box lid, which fuse or fuses control that device. Check those fuses first, but check all the fuses before deciding that a blown fuse is the cause. Replace any blown fuses, and check if the device works. 1. Turn the ignition switch to the LOCK (0) position. Make sure the headlights and all other accessories are off. FUSE PULLER BLOWN 2. Remove the cover from the underhood fuse box located on the battery (see page 406 ). 3. Check each of the large fuses in the under-hood fuse box on the 12 volt battery by looking through the top at the wire inside. Replacement of these fuses should be done by your dealer. 4. Check the smaller fuses in the under-hood fuse boxes and all the fuses in the interior fuse box by pulling out each one with the fuse puller provided in the interior fuse box. Taking Care of the Unexpected CONTINUED 407 2010 Insight