2010 Honda Insight Owner's Manual - Page 431

Emissions Testing Testing of Readiness Codes If you take your vehicle for an emissions test shortly after the battery has been disconnected or gone dead, it may not pass the test. This is because of certain ''readiness codes'' that must be set in the onboard diagnostics for the emissions systems. These codes are erased when the battery is disconnected, and set again only after several days of driving under a variety of conditions. If the testing facility determines that the readiness codes are not set, you will be requested to return at a later date to complete the test. If you must get the vehicle retested within the next two or three days, you can condition the vehicle for retesting by doing the following. 1. Make sure the gas tank is nearly, but not completely, full (around 3/4). 2. Make sure the vehicle has been parked with the engine off for 6 hours or more. 3. Make sure the ambient temperature is between 40° and 95°F (4° and 35°C). 4. Without touching the accelerator pedal, start the engine, and let it idle for 20 seconds. 5. Keep the vehicle in Park. Increase the engine speed to 2,000 rpm, and hold it there until the temperature gauge rises to at least 1/4 of the scale (about 3 minutes). 6. Without touching the accelerator pedal, let the engine idle for 20 seconds. 428 2010 Insight