2003 Hyundai Elantra Owner's Manual - Page 63

FEATURES OF YOUR HYUNDAI B660F01E-AAT To Reset at a Slower Speed B660B01E 1. Push the control switch downward to "SET (COAST)" and hold it. The vehicle will decelerate. 2. When the desired speed is obtained, release the control switch. While the control switch is pushed, the vehicle speed will gradually decrease. o During cruise-control driving with a manual transaxle vehicle, do not shift into neutral without depressing the clutch pedal, or the engine will be overrevved. If this happens, depress the clutch pedal or release the main switch. o With the cruise control engaged, when the brake pedal is applied, it is normal to hear the cruise control system deactivate. This is an indication of normal system operation. o During normal cruise control operation, when the "SET(COAST)" is activated or reactivated after applying the brakes, the cruise control will energize after approximately 3 seconds. This delay is normal. This model has four controls for the heating and cooling system. They are: 1. 2. 3. 4. Air flow control Air intake control Temperature control Fan speed control B670B02A-AAT Fan Speed Control (Blower Control) B670A01A-AAT HEATING AND VENTILATION ROTARY TYPE (If Installed) 1 2 3 B670A01E WARNING: o Keep the main switch off when not using the cruise control. o Do not use the cruise control when it may not be safe to keep the car at a constant speed, for instance, driving in heavy or varying traffic, or on slippery (rainy, icy or snow-covered) or winding roads or over 6% up-hill or down-hill roads. o Pay particular attention to the driving conditions whenever using the cruise control system. 1- 54 This is used to turn the blower fan on or off and to select the fan speed. This blower fan speed, and therefore the volume of air delivered from the system, may be controlled manually by setting the blower control between the "1" and "4" positions. NOTE: 4 HXDOM046 If the blower fan is off, it will set to the fresh mode automatically and be able to select "Fresh"mode or "Recirculation" mode.