2003 Hyundai Elantra Owner's Manual - Page 70

FEATURES OF YOUR HYUNDAI B970C02E-AAT Automatic Operation Photo sensor HXD118A G280A01E HXD118D The FATC (Full Automatic Temperature Control) system automatically controls heating and cooling as follows: 1. Push the "AUTO" switch. The indicator light will illuminate confirming that the Face, Floor and/or Bi-Level modes as well as the blower speed and, air conditioner will be controlled automatically. 2. Push the "TEMP" button to set the desired temperature. The temperature will increase to the maximum 90°F(32°C) by pushing on the button. Each push of the button will cause the temperature to increase by 1°F(0.5°C). The temperature will decrease to the minimum 62°F(17°C) by pushing on the button. Each push of the button will cause the temperature to decrease by 1°F(0.5°C). NOTE: Never place anything over the sensor which is located on the instrument panel to ensure better control of the heating and cooling system. B995A01Y-GAT AMBIENT SWITCH NOTE: If the battery has been discharged or disconnected, the temperature mode will reset to centigrade degrees. This is a normal condition and you can change the temperature mode from centigrade to farenheit as follows; Press the TEMP button down 3 seconds or more with the OUTSIDE button held down. The TEMP display shows that the unit of temperature is adjusted to contigrade or fahrenheit. (°C °F or °F °C) HXD118I 1- 61