2003 Hyundai Elantra Owner's Manual - Page 86

FEATURES OF YOUR HYUNDAI B260D02O-AAT 1. Playing CD o Insert the CD with the label facing upward. o Insert the CD to start CD playback, during radio operation. o When a disc is in the CD deck, if you press the play button, the CD player will begin playing even if the radio is being used. o The CD player can be used when the ignition switch is in either the "ON" or "ACC" position. 5. REPEAT Button o To repeat the music you are listening to, press the RPT button. To cancel , press again. o If you do not release RPT operation, when the track ends, it will automatically be replayed. This process will be continued until you push the button again. 6. EJECT Button When the EJECT button is pressed with the CD loaded, the CD is ejected. 2. FF/REW ( / ) If you want to fast forward or reverse through the compact disc track, push and hold in the FF ( ) or REW ( ) button. When you release the button, the compact disc player will resume playing. NOTE: o If the CD does not operate properly or if the ER2 fault code is displayed, use one of two methods to reset the CD deck function. - Remove the audio fuse for 5 minutes. Then, reinstall the audio fuse. - Disconnect the negative terminal of the battery and wait 5 minutes. Then reconnect the negative battery terminal. o To assure proper operation of the unit, keep the vehicle interior temperature within a normal range by using the vehicle's air conditioning or heating system. 3. TRACK UP/DOWN o The desired track on the disc currently being played can be selected using the track number. o Press once to skip forward to the beginning of the next track. Press once to skip back to the beginning of the track. o When replacing the fuse, replace it with a fuse having the correct capacity. o The preset station frequencies are all erased when the car battery is disconnected. Therefore, all data will have to be set again if this should occur. o Do not add any oil to the rotating parts. Keep magnets, screwdrivers and other metallic objects away from the tape mechanism and head. o This equipment is designed to be used only in a 12 volt DC battery system with negative ground. o This unit is made of precision parts. Do not attempt to disassemble or adjust any parts. o When driving your vehicle, be sure to keep the volume of the unit set low enough to allow you to hear sounds coming from the outside. o Do not expose this equipment (including the speakers) to water or excessive moisture. 4. SCAN Button o Press the SCAN button to playback the first 10 seconds of each track. o Press the SCAN button again within 10 sec. for the desired track. 1- 77