2003 Hyundai Santa Fe Owner's Manual - Page 69

FEATURES OF YOUR HYUNDAI 1- 57 Programming Your vehicle may require that the ignition switch to be turned to the "ACC" position to program and/or operate HomeLink system. It is also recommended that a new battery be placed in the handheld transmitter of the device being programmed to HomeLink for quicker programming and accurate transmission of the radiofrequency. Follow these steps to program your HomeLink mirror: Flashing Additional Programming for Rolling Code Devices For any rolling-code-equipped device; follow the steps below after completing the "Programming" section. A second person may make the following steps easier. 1. Locate the "learn" or "smart" button on the device's motor head unit. The exact location and color of the button varies by product brand, but is usually referenced in the device's owner's manual. Contact HomeLink at 1800-355-3515 or www.homelink.com for help. 2. Press and release the "learn" or "smart" button on the device's motor head unit. Transmitter B520C03L Flashing B520C02L 1. When programming the buttons for the first time, press and hold the two outside HomeLink buttons ( , ), releasing when the indicator light begins to flash (approximately 20 seconds). This procedure erases the factory-set default codes. Do not perform this step when programming additional transmitters. 2. Hold the transmitter of the device you want to program 1 to 3 inches away from the bottom of the mirror. Simultaneously press the handheld transmitter button and the HomeLink button you wish to program. The indicator light will flash slowly at first, then rapidly, indicating successful programming. 3. If the garage door opener or other device you wish to program is rolling-code equipped, proceed to the "Rolling Code Programming" section. 4. Repeat step 2 to program the remaining HomeLink buttons. 1 ~ 3 in ch es NOTE: You now have 30 seconds to initiate step 3. 3. Return to the vehicle and firmly press and release the programmed HomeLink button. Press and release the same HomeLink button a second time to complete the programming process. (Some devices may require you to press and release a third time to complete the programming.) 4. Now HomeLink mirror and rolling-codeequipped device should be synchronized. The remaining HomeLink buttons may now be programmed if this has not been done previously.