2003 Hyundai Tiburon Owner's Manual - Page 148

2003 Hyundai Tiburon Manual

Page 148 highlights

DO-IT-YOURSELF MAINTENANCE NOTE: Grinding noise from the power steering pump may be heard immediately after the engine is started in extremely cold conditions (below - 4°F). If the noise stops during warm up, there is no abnormal function in the system. It is due to a power steering fluid characteristic in extremely cold conditions. Recommended Fluid Use PSF-3 type fluid manual used by dealership technicians and while it is highly technical it can be useful in obtaining a better understanding of your car and how it works. G260A02A-AAT REPLACING HEADLIGHT BULBS Before attempting to replace a headlight bulb, be sure the switch is turned to the "OFF" position. The next paragraph shows how to reach headlight bulbs so they may be changed. Be sure to replace the burned-out bulb with one of the same number and wattage rating. NOTE: Do not start the engine when the power steering oil reservoir is empty. G240A01A-AAT CAUTION: Keep the lamps out of contact with petroleum products such as oil, gasoline etc. G270A02A-GAT 1. Allow the bulb to cool. Wear eye protection. 2. Always grasp the bulb by its plastic base, avoid touching the glass. 3. Disconnect the power cord from the bulb base in the back of the headlight. 4. Remove the dust cover. 5. Push the bulb spring for removing the headlight bulb. 6. Remove the protective cap from the replacement bulb and install the new bulb by matching the plastic base with the headlight hole. Install the dust cover after retightening the bulb spring and reconnect the power cord. 7. Use the protective cap and carton to dispose of the old bulb. 8. Check for proper headlight aim. POWER STEERING HOSES It is suggested that you check the power steering hose connections for fluid leakage at regular intervals. The power steering hoses should be replaced if there is severe surface cracking, scuffing or worn spots. Deterioration of the hose could cause premature failure. G250A01A-AAT WARNING: HEADLIGHT BULB Replacement instructions: Turn signal Light The halogen bulb contains gas under pressure and if impacted could shatter, resulting in flying fragments. Always wear eye protection when servicing the bulb. Protect the bulb against abrasions or scratches and against liquids when lighted. Turn the bulb on only when installed in a headlight. Replace the headlight if damaged or cracked. Keep the bulb out of the reach of children and dispose of the used bulb with care. FOR MORE INFORMATION ABOUT YOUR HYUNDAI If you desire additional information about maintaining and servicing your Hyundai, you may purchase a factory Shop Manual at your Hyundai dealer's parts department. This is the same Low Beam High Beam HGK225 6-17

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.