2003 Hyundai Tiburon Owner's Manual - Page 149

DO-IT-YOURSELF MAINTENANCE G290A02GK-AAT HEADLIGHT AIMING ADJUSTMENT Low Beam Vertical aiming And then, draw the parallel line at 0.827 in. (21 mm) under the horizontal line. 7. Adjust each cut-off line of the low beam to the parallel line with a phillips screwdriver VERTICAL AIMING. 8. Adjust each cut-off line of the low beam to the each vertical line with a phillips screwdriver - HORIZONTAL AIMING. 1. Adjust headlights so that main axis of light is parallel to center line of the body and is aligned with point "P" shown in the illustration. 2. Dotted lines in the illustration show the center of headlights. SPECIFICATION: "H" Horizontal center line of headlights from ground: Low Beam: 26.7 in. (679mm) High Beam: 26.5 in. (672mm) "W" Distance between each headlight center : Low Beam: 47.3 in. (1,202mm) High Beam: 38.0 in. (966mm) "L" Distance between the headlights and the wall that the lights are tested against : 118 in. (3,000 mm) WARNING: Horizontal aiming G290A03GK Horizontal aiming should be adjusted by an authorized Hyundai Dealer. G290B01GK-AAT Before performing aiming adjustment, make sure of the following. 1. Keep all tires inflated to the correct pressure. 2. Place the vehicle on level ground and press the front bumper & rear bumper down several times. Place vehicle at a distance of 118 in. (3m) from the test wall. 3. See that the vehicle is unloaded (except for full levels of coolant, engine oil and fuel, and spare tire, jack, and tools). 4. Clean the head light lenses and turn on the headlights (low beam). 5. Open the hood. 6. Draw the vertical line (through the center of each headlight beam pattern) and the horizontal line (through the center of each headlight beam pattern) on the aiming screen. 6-18 Adjustment After Headlight Assembly Replacement 0.827in.(21mm) Horizontal line W Vertical line "P" H Cut-off line L Ground line G290B01GK H If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming should be checked using the aiming screen as shown in the illustration. Turn on the headlight switch.