2004 Hyundai Elantra Owner's Manual - Page 123

1 FEATURES OF YOUR HYUNDAI 112 B260F02E-AAT The CD auto changer is located in the left side of the trunk. o To use the CD auto changer. 1. Open the sliding lid of the CD auto changer. 2. To eject the compact disc magazine, press the EJECT button located inside the CD auto changer. 3. Insert the discs into the magazine. 4. Push the magazine into the CD auto changer and close the sliding lid. o The CD auto changer can be used when the ignition switch is in either the "ON" or "ACC" position. 3. TRACK UP/DOWN o The desired track on the disc currently being played can be selected using the track number. o Press once to skip forward to the beginning of the next track. Press once to skip back to the beginning of the track. NOTE: o When replacing the fuse, replace it with a fuse having the correct capacity. o This equipment is designed to be used only in a 12 volt DC battery system with negative ground. o This unit is made of precision parts. Do not attempt to disassemble or adjust any parts. o When driving your vehicle, be sure to keep the volume of the unit set low enough to allow you to hear sounds coming from the outside. 4. FF/REW ( / ) If you want to fast forward or reverse through the compact disc track, push and hold in the FF ( ) or REW ( ) button. When you release the button, the compact disc player will resume playing. 5. REPEAT 1. CD Select Button When the CD changer magazine contains discs, press the "CD" button and the CD changer can be used even if the radio is being used. The Hyundai CD changer can hold up to eight discs. The disc number will be lit, and the track number, and elapsed time will be displayed. o To repeat the track you are listening to, press the RPT button. To cancel , press again. o If you do not release RPT operation when the track ends, it will automatically be replayed. This process will be continued until you push the button again. ! CAUTION: Do not insert warped or poor quality discs into the CD changer as damage to the unit may occur. 2. DISC Select Button To select the CD you want, push the disc number. TUNE DISC 6. SCAN Button to change o Press the SCAN button to playback the first 10 seconds of each track. o Press the SCAN button again within 10 sec. for the desired track.