2004 Hyundai Santa Fe Owner's Manual - Page 193

5 VEHICLE MAINTENANCE REQUIREMENTS 8 F065F01O-AAT F060H01A-AAT F070D01A-AAT o Crankcase Ventilation Hose Inspect the surface of hose for evidence of heat and/or mechanical damage. Hard and brittle rubber, cracking, tears, cuts, abrasions, and excessive swelling indicate deterioration. Particular attention should be paid to examine that hose surface nearest to high heat sources, such as the exhaust manifold. Inspect the hose routing to assure that the hose does not come in contact with any heat source, sharp edges or moving component which might cause heat damage or mechanical wear. Inspect all hose connections, such as clamps and couplings, to make sure they are secure, and that no leaks are present. Hose should be replaced immediately if there is any evidence of deterioration or damage. o Air Cleaner Filter A Genuine Hyundai air cleaner filter is recommended when the filter is replaced. F060J01A-AAT o Manual Transaxle Oil Inspect the manual transaxle oil according to the maintenance schedule. NOTE: If the oil level is low, check for possible leaks before adding oil. Do not overfill. o Spark Plugs Make sure to install new spark plugs of the correct heat range. F070E03A-AAT o Automatic Transaxle Fluid and Filter F060E01A-AAT o Timing Belt Inspect all parts related to the timing belt for damage and deformation. Replace any damaged parts immediately. F060G01A-AAT F070C01A-AAT o Vapor Hose and Fuel Filler Cap The vapor hose and fuel filler cap should be inspected at those intervals specified in the maintenance schedule. Make sure that a new vapor hose or fuel filler cap is correctly replaced. o Coolant The coolant should be changed at the intervals specified in the maintenance schedule. The fluid level should be in the "HOT" range of the dipstick, after the engine and transaxle are at normal operating temperature. Check the automatic transaxle fluid level with the engine running and the transaxle in neutral, with the parking brake properly applied. Use GENUINE HYUNDAI ATF or DIAMOND ATF SP-III or SK ATF SP-III when adding or changing fluid. F070F01A-AAT o Brake Hoses and Lines Visually check for proper installation, chafing, cracks, deterioration and any leakage. Replace any deteriorated or damaged parts immediately.