2005 Hyundai Accent Owner's Manual - Page 112

2005 Hyundai Accent Manual

Page 112 highlights

2 DRIVING YOUR HYUNDAI 6 o If you've come to a complete stop and it's hard to shift into 1st or R(Reverse), put the shift lever in N(Neutral) position and release the clutch. Press the clutch pedal back down, and then shift into 1st or R(Reverse) gear position. o Do not use the shift lever as a handrest during driving, as this can result in premature wear of the transaxle shift forks. C070B01A-AAT C070D02O-AAT Using the Clutch The clutch should be pressed all the way to the floor before shifting, then released slowly. Do not rest your foot on the clutch pedal while driving. This can cause unnecessary wear. Do not partially engage the clutch to hold the car on an incline. This causes unnecessary wear. Use the parking brake to hold the car on an incline. Do not operate the clutch pedal rapidly and repeatedly. Good Driving Practices o Never take the car out of gear and coast down a hill. This is extremely hazardous. Always leave the car in gear. o Don't "ride" the brakes. This can cause them to overheat and malfunction. Instead, when you are driving down a long hill, slow down and shift to a lower gear. When you do this, engine braking will help slow the car. o Slow down before shifting to a lower gear. This will help avoid over-revving the engine, which can cause damage. o Slow down when you encounter cross winds. This gives you much better control of your car. o Be sure the car is completely stopped before you attempt to shift into reverse. The transaxle can be damaged if you do not. To shift into reverse, depress the clutch, move the shift lever to neutral, wait three seconds, then shift to the reverse position. o Exercise extreme caution when driving on a slippery surface. Be especially careful when braking, accelerating or shifting gears. On a slippery surface, an abrupt change in vehicle speed can cause the drive wheels to lose traction and the vehicle to go out of control. ! CAUTION: When downshifting from fifth gear to fourth gear, caution should be taken not to inadvertently press the gear shift lever sideways in such a manner that second gear is engaged. Such a drastic downshift may cause the engine speed to increase to the point that the tachometer will enter the red zone. Such over revving of the engine may possibly cause engine damage. C070E03A-AAT RECOMMENDED SHIFT POINTS Shift from-to 1-2 2-3 3-4 4-5 Recommended mph(km/h) 15 (20) 25 (40) 35 (55) 45 (75) The shift points as shown above are recommended for optimum fuel economy and performance.

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.