2005 Hyundai Accent Owner's Manual - Page 89

FEATURES OF YOUR HYUNDAI 1 77 H210B04O-AAT 1. POWER ON-OFF/VOLUME Control Knob The radio unit may be operated when the ignition key is in the "ACC" or "ON" position. Rotate the knob clockwise to switch the radio unit on and to increase the volume. The LCD shows the radio frequency in the radio mode. Turn the knob counterclockwise to reduce the volume and to switch the radio unit off. 2. FAD (Fader Control) Knob Turn the control knob counterclockwise to emphasize front speaker sound (rear speaker sound will be attenuated). When the control knob is turned clockwise, rear speaker sound will be emphasized (front speaker sound will be attenuated). SEEK Operation (Automatic Channel Selection) Press the TUNE select button for 1 sec. or more. When the ( ) side is pressed, the unit will automatically tune to the next higher frequency and when the ( ) side is pressed, it will automatically tune to the next lower frequency. 3. BASS Control Knob Press to pop the knob out and turn to the left or right for the desired bass tone. 6. PRESET STATION SELECT Button Six (6) stations for AM, FM1 and FM2 respectively can be preset in the electronic memory circuit on this unit. BAL (Balance Control) Knob Pull and turn the control knob clockwise to emphasize right speaker sound (left speaker sound will be attenuated). When the control knob is turned counterclockwise, left speaker sound will be emphasized (right speaker sound will be attenuated). After adjusting the balance, push the knob again to use the other function. TREBLE Control Knob. Pull the bass control knob further out. Turn to the left or right for the desired treble tone. HOW TO PRESET STATIONS Six AM and twelve FM stations may be programmed into the memory of the radio. Then, by simply pressing the band select button and/or one of the six station select buttons, you may recall any of these stations instantly. To program the stations, follow these steps: o Press band selector to set the band for AM, FM1, and FM2. o Select the desired station to be stored by seek, scan or manual tuning. o Determine the preset station select button you wish to use to access that station. 4. BAND Selector Pressing the FM button changes the AM, FM1 AM and FM2 bands. The mode selected is displayed on LCD. SCAN Knob When the scan knob is pressed, the frequency will increase and the receivable stations will be tuned in one after another, receiving each station for 5 seconds. To stop scanning, press the scan knob again. 5. TUNE (Manual) Select Button Press the ( ) side or ( ) side to increase or to decrease the frequency. With the button held down for 1 sec. or more, the stop signal (broadcasting radio wave) is ignored and channel selection continues.