2005 Hyundai Elantra Owner's Manual - Page 147

2 DRIVING YOUR HYUNDAI 6 NOTE: o To shift into reverse, rest the lever in neutral for at least 3 seconds after your car is completely stopped. Then move the lever into the reverse position. o During cold weather, shifting may be difficult until the transaxle lubricant has warmed up. This is normal and not harmful to the transaxle. o If you 've come to a complete stop and it's hard to shift into 1st or R(Reverse), put the shift lever in N(Neutral) position and release the clutch. Press the clutch pedal down, and then shift into 1st or R(Reverse) gear position. o Do not use the shift lever as a handrest during driving, as this can result in premature wear of the transaxle shift forks. C070B03A-AAT C070E03A-AAT Using the Clutch The clutch should be pressed all the way to the floor before shifting, then released slowly. The clutch pedal should always be fully released while driving. Do not rest your foot on the clutch pedal while driving. This can cause unnecessary wear. Do not partially engage the clutch to hold the car on an incline. This causes unnecessary wear. Use the foot brake or parking brake to hold the car on an incline. Do not operate the clutch pedal rapidly and repeatedly. Recommended Shift Points Shift from-to 1-2 2-3 3-4 4-5 Recommended mph (km/h) 15 (20) 25 (40) 35 (55) 45 (75) The shift points as shown above are recommended for optimum fuel economy and performance. ! CAUTION: When downshifting from fifth gear to fourth gear, caution should be taken not to inadvertently press the gear shift lever sideways in such a manner that second gear is engaged. Such a drastic downshift may cause the engine speed to increase to the point that the tachometer will enter the red zone. Such over-revving of the engine may cause engine damage.