2005 Hyundai Santa Fe Owner's Manual - Page 140

FEATURES OF YOUR HYUNDAI 1 129 D295B02O-AAT 1. POWER ON•OFF Control Knob Press this knob to turn the system on and off. SCAN Press and hold either SEEK/SCAN arrow for two seconds until SCAN appears on the display and you hear a beep. Use SCAN to listen to stations for a few seconds. The radio will go to a station, stop for a few seconds, then go to the next station. Press either SEEK/SCAN arrow again to stop scanning. If you press SEEK/ SCAN for more than four seconds, the radio will change to preset scan mode. Then sound will mute while scanning. PRESET SCAN Press and hold either SEEK/SCAN arrow for more than four seconds, PRESET SCAN will appear on the display. You will hear a double beep. Use PERSET SCAN to listen to each of your preset stations for a few seconds. The radio will go to a preset station stored on your pushbuttons, stop for a few seconds, then go on to the next preset stations. Press either SEEK/ SCAN arrow again to stop scanning presets. VOLUME Control To increase volume, turn the knob clockwise. Turn it counterclockwise to decrease volume. 2. BAND Select Button Press this button to switch between AM, FM1 and FM2. Then Display shows your selection. 5. PRESET STATION Select Button The six numbered pushbuttons let you return to your favorite stations. You can set up to 18 stations (six AM, six FM1 and six FM2) by performing the following steps: 1. 2. 3. 4. Turn the radio on. Press AM · FM to select the band. Tune in the desired station. Press AUTO EQ to select the equalization that best suited type of station selected. 5. Press and hold one of the six numbered buttons until you hear a beep. Whenever you press that numbered button, the station you set will return and the equalization that you selected will also be automatically selected for that button. 6. Repeat the above steps for each pushbutton. 6. AUDIO Knob BASS Press the AUDIO knob until BASS appears on the display. Turn the knob to increase or decrease bass. When you use this control, the radio's tone setting will switch to custom mode. To set the bass to the middle position, select BASS and press and hold the AUDIO knob. The radio will produce one beep and set the display level to zero. To set all tone and speaker controls to the middle position, press and hold the AUDIO knob when no tone or speaker control is active. The radio will produce one beep and CENTERED will appear on the display. 3. RADIO STATION Control Knob Turn this knob to select radio stations. 4. SEEK/SCAN Button SEEK Press the up or down arrow to go to the next higher or lower station and stay there. The sound will mute while seeking.