2005 Hyundai Santa Fe Owner's Manual - Page 165

DRIVING YOUR HYUNDAI 2 15 SLIP Control Limits the drive wheels from spinning excessively during starting or while making accelerated turns on slippery roads to avoid losing the driving force of the front wheels. C310B02O-AAT C310D01JM-AAT TCS ON/OFF Mode When the TCS is operating, the TCS indicator in the instrument cluster will blink. If you turn the system off by pressing the TCS switch, the TCS-OFF indicator will come on and stay on. In the TCS-OFF mode, the SLIP control will be deactivated. Adjust you driving accordingly. To turn the system back on, press the switch again. The TCS-OFF indicator should go off. Indicators and Warning The indicators should illuminate when the ignition key is turned to ON or START but should go out after approximately three seconds. If the indicators do not illuminate, or the TCS or TCS-OFF indicator does not go out after 3 seconds, have the system checked by an authorized dealer. Should there be any unusual conditions in the TCS System while driving, TCS-OFF indicator illuminates as a warning. If TCS-OFF indicator illuminates, pull your car to a safe place and stop the engine. Then, start the engine again to check if the TCSOFF indicator goes out. If the indicator remains lit even after the engine has been started, have your car checked by an authorized Hyundai dealer. Driving Hints TCS does not actively apply brakes. Be sure to decelerate the car sufficiently before entering curves. NOTE: ! CAUTION: When the TCS indicator blinks, SLIP control has been activated. It also means that the road is slippery or your car is accelerating excessively. In this situation, release foot pressure from the accelerator pedal and maintain moderate speed. ! WARNING: Traction control is only a driving aid; all normal precautions for driving in inclement weather and on slippery road surfaces should be observed. 1) The TCS mode will automatically be turned ON after the engine is turned off and restarted. 2) When the traction control system is operating properly, you can feel a slight pulsation in the vehicle. This is only the effect of brake control and indicates nothing unusual. 3) When the engine starts, a click may be heard from the engine compartment; this is the sound of the traction control being checked. 4) When moving out of the mud or fresh snow, pressing the accelerator pedal may not cause the engine speed to increase due to TCS operation. NOTE: When the TCS-OFF indicator illuminates, traction control is automatically deactivated.