2005 Hyundai Santa Fe Owner's Manual - Page 75

1FEATURES OF YOUR HYUNDAI 64 Correcting Azimuth Indicator It is needed to correct the error between a current azimuth to terrestrial magnetism sensor and the displayed azimuth in the vehicle position. How to correct azimuth indicator 1. If you push and hold the "M (MODE)" switch for less than 4.5 seconds, the azimuth indicator will start blinking with the vehicle's present direction. 3. When the rotation is finished, the azimuth compass indicator will stop blinking and the error correction is completed. If the indicator continues to blink, rotate the vehicle a bit more until the blinking stops. The compass heading will appear after 3 seconds when the correcting error is completed. The azimuth compass indicator correction will be cancelled: 1. If you press "M (MODE)" switch for more than 0.5 second. 2. When the vehicle is not rotated within 128 seconds after the blinking of the indicator. NOTE: The azimuth may display abnormally in specific places (tunnel, parking lot in building, underground parking lot, near transformer substation, etc.). It is normal and the azimuth is displayed normally when escaping above mentioned places. How to correct terrestrial deviation. 1. Press "M (MODE)" switch for more than 4.5 seconds, then the present terrestrial deviation angle value will be displayed. 2. Press " (UP)" or " (DOWN)" switch for less than 0.5 second to correct the terrestrial deviation angle within 30 seconds. HSM2186 NOTE: HSM2185 Rotate the vehicle one turn (90 degree) as shown in the drawing if the vehicle has no place to rotate. 2. Slowly rotate the vehicle one turn(360 degree) within 128 seconds. The rotation could be made at any direction(left or right) in an open space.