2005 Hyundai Sonata Owner's Manual - Page 147

DRIVING YOUR HYUNDAI 2 3 BEFORE STARTING THE ENGINE C020A01A-AAT TO START THE ENGINE C030A01E-AAT KEY POSITIONS C040A01A-AAT Before you start the engine, you should always: 1. Look around the vehicle to be sure there are no flat tires, puddles of oil, water or other indications of possible trouble. 2. After entering the car, check to be sure the parking brake is engaged. 3. Check that all windows and lights are clean. 4. Check that the interior and exterior mirrors are clean and in position. 5. Check your seat, seatback and headrest to be sure they are in their proper positions. 6. Lock all the doors. 7. Fasten your seat belt and be sure that all other occupants have fastened theirs. 8. Turn off all lights and accessories that are not needed. 9. When you turn the ignition switch to "ON", check that all appropriate warning lights are operating and that you have sufficient fuel. 10. Check the operation of warning lights and all bulbs when key is in the "ON" position. COMBINATION IGNITION SWITCH o If your Hyundai is equipped with a manual transaxle, place the shift lever in neutral and depress the clutch pedal fully. o If your Hyundai has an automatic transaxle, place the shift lever in "P" (park). o To start the engine, insert the ignition key and turn it to the "START" position. Release it as soon as the engine starts. Do not hold the key in the "START" position for more that 15 seconds. ACC LOCK ON START NOTE: o For safety, the engine will not start if the clutch pedal is not depressed fully (Manual Transaxle) or the shift lever is not in "P" or "N" Position (Automatic Transaxle). o The ignition key cannot be turned from "ACC" position to "LOCK" position unless the shift lever is in the "P" (Park) position or the negative battery terminal is disconnected from the battery. To remove the key, always confirm that the shift lever is securely positioned in "P" (Park) (For Automatic Transaxle). o For additional information about starting, see page 2-4. C040A01E ! CAUTION: The engine should not be turned off or the key removed from the ignition key cylinder while the car is in motion. The steering wheel is locked by removing the key. o "START" The engine is started in this position. It will crank until you release the key.