2005 Hyundai Tiburon Owner's Manual - Page 19

1FEATURES OF YOUR HYUNDAI 8 B070E02GK-GAT POWER WINDOW B050A01GK-AAT Replacing the battery When the transmitter's battery begins to get weak, it may take several pushes on the button to lock or unlock the doors, and the LED will not light. Replace the battery as soon as possible. Battery type : CR2032 Replacement instructions: Battery HGK121 HGK2015 (1) 2. Remove the old battery from the case and note the polarity. Make sure the polarity of the new battery is the same(+side facing down), then insert it in the transmitter. NOTE: Screwdriver HGK122 Install a new battery within 30 seconds after removing the old one. If installing a new battery takes more than 30 seconds, take the following steps. 1) Turn the ignition key to the "ACC" position. 2) Make sure that the turn signal lamps blink once by pushing the "LOCK" or "UNLOCK" button on the transmitter. 1. Carefully separate the case with a blade screwdriver as shown in the illustration. The power windows operate only when the ignition key is in the "ON" position. The main switches are located on the driver's arm rest and control the front windows on the respective sides of the vehicle. The windows may be opened by depressing the front portion of the switch. To stop at the desired opening, release the switch. The window may be closed by pulling the front portion of the switch. In order to prevent operation of the passenger front window by the passenger, a window lock switch (1) is provided on the arm rest of the driver's door. To disable the passenger's power window, push the window lock switch. To revert to normal operation, push in on the window lock switch again.