2006 Hyundai Santa Fe Owner's Manual - Page 238

DO-IT-YOURSELF MAINTENANCE 6 25 6. Draw a vertical line (through the center of each headlight beam pattern) and a horizontal line (through the center of each headlight beam pattern) on the aiming screen. And then, draw a parallel line at 0.8 in. (21 mm) under the horizontal line. 7. Adjust each cut-off line of the low beam to the parallel line with a phillips screwdriver VERTICAL AIMING. G290B01O-AAT Adjustment After Headlight Assembly Replacement Vertical line Horizontal line W SPECIFICATION: "H"; Horizontal center line of headlights from ground: 2WD : 32.5 in.(822 mm) 4WD : 33.3 in.(843 mm) "W"; Distance between each headlight center: 46.5 in.(1,178 mm) "L"; Distance between the headlights and the wall that the lights are tested against: 118 in. (3,000 mm). "P" H ! Cut-off line WARNING: H Horizontal aiming should be adjusted by an authorized Hyundai dealer. L Ground line G290A03O If the vehicle has had front body repair and the headlight assembly has been replaced, the headlight aiming should be checked using an aiming chart as shown in the illustration. Turn on the headlight switch. (Low Beam Position) 1. Adjust headlights so that main axis of light is parallel to center line of the body and is aligned with point "P" shown in the illustration. 2. Dotted lines in the illustration show the center of headlights.