2006 Hyundai Santa Fe Owner's Manual - Page 44

1FEATURES OF YOUR HYUNDAI 32 After installation of the child restraint system, try to move it in all directions to be sure the child restraint system is securely installed. If you need to tighten the belt, pull more webbing toward the retractor. When you unbuckle the seat belt and allow it to retract, the retractor will automatically revert back to its normal seated passenger Emergency Locking usage condition. B180C01O-AAT Pre-Tensioner Seat Belt Your Hyundai vehicle is equipped with driver's and front passenger's pre-tensioner seat belts. The purpose of the pre-tensioner is to make sure that the seat belts fit tightly against the occupant's body in certain frontal collisions. The pre-tensioner seat belts can be activated alone or, where the frontal collision is severe enough, together with the airbags. When the pre-tensioner activates, if the system senses excessive seat belt tension on the driver or passenger's seat belt, the load limiter inside the pre-tensioner will release some of the pressure on the affected seat belt. Driver's airbag 1 Passenger's airbag NOTE: o Before installing the child restraint system in any seating position, read the instructions supplied by the child restraint system manufacturer. o If the seat belt does not operate as described, have the system checked immediately by your authorized Hyundai dealer. 2 3 B180B01O ! WARNING: o If the retractor is not in the Automatic Locking mode, the child restraint system can move when your vehicle turns or stops abruptly. o Do not install any child restraint system in the front passenger seat. Should an accident occur and cause the passenger side airbag to deploy, it could severely injure or kill an infant or child seated in an infant or child seat. Therefore, only use a child restraint system in the rear seat of your vehicle. The seat belt pre-tensioner system consists mainly of the following components. Their locations are shown in the illustration. HXG229 When the vehicle stops suddenly, or if the occupant tries to lean forward too quickly, the seat belt retractor will lock into position. In certain frontal collisions, the pre-tensioner will activate and pull the seat belt into tighter contact against the occupant's body. 1. SRS airbag warning light 2. Seat belt pre-tensioner assembly 3. SRS control module