2006 Hyundai Santa Fe Owner's Manual - Page 76

1FEATURES OF YOUR HYUNDAI 64 Correcting Azimuth Indicator The display before correction mode is set as "C". It is needed to correct the indicator between a current azimuth to terrestrial magnetism sensor and the displayed azimuth in the vehicle position. 3. When the rotation is finished, the current azimuth indicator will appear and the correction mode is completed. If the indicator continues to blink, rotate the vehicle a bit more until the blinking stops. The azimuth compass indicator correction will be cancelled: 1. If you press "M (MODE)" switch for more than 0.5 second. 2. When the vehicle is not rotated within 128 seconds after the blinking of the indicator. How to correct azimuth indicator 1. If you push and hold the "M (MODE)" switch for less than 4.5 seconds, the "C" will start blinking. NOTE: The azimuth may display abnormally in specific places (tunnel, parking lot in building, underground parking lot, near transformer substation, etc.). It is normal and the azimuth is displayed normally when escaping above mentioned places. How to correct terrestrial deviation. HSM2186 NOTE: Rotate the vehicle one turn (90 degree) as shown in the drawing if the vehicle has no place to rotate. After the correction mode is completed, the compass heading will appear 3 seconds later. 1. Press "M (MODE)" switch for more than 4.5 seconds, then the present terrestrial deviation angle value will be displayed. 2. Press " (UP)" or " (DOWN)" switch for less than 0.5 second to correct the terrestrial deviation angle within 30 seconds. HSM2185 2. Slowly rotate the vehicle one turn(360 degree) within 128 seconds. The rotation could be made at any direction(left or right) in an open space.