2007 Hyundai Accent Owner's Manual - Page 108

1 FEATURES OF YOUR HYUNDAI 96 TRUNK LID/TAIL GATE B540A01MC-GAT Trunk Lid (4 Door) o The trunk lid is opened by first turning the key clockwise to release the lock, then raising the door manually. o To close, lower the trunk lid, then press down on it until it locks. To be sure the trunk lid is securely fastened, try to pull it up again. ! WARNING: - When refueling always shut the engine off. Sparks produced by electrical components related to the engine can ignite fuel vapors causing a fire. Always insure that the engine is OFF before and during refueling. Once refueling is complete, check to make sure the fuel filler cap and door are securely closed, before starting the engine. - Do not light any fire around a gas station. DO NOT use matches or a lighter and DO NOT SMOKE or leave a lit cigarette in your vehicle while at a gas station especially during refueling. Automotive fuel is highly flammable and can, when ignited, result in explosion by flames. - If a fire breaks out during refueling, leave the vicinity of the vehicle, and immediately contact the manager of the gas station or contact the police and local fire department. Follow any safety instructions they provide. Tail Gate (3 Door) OMC025010 ! WARNING: The trunk lid or the tail gate should always be kept completely closed while the vehicle is in motion. If it is left open or ajar, poisonous exhaust gases may enter the car resulting in serious illiness or death to the occupants. See additional warnings concerning exhaust gases on page 2-2. To open the tail gate, unlock it by turning the key clockwise, then pull the outside handle toward you. To close, lower the tail gate and shut firmly to engage the latch. Lock the tail gate by turning the key counterclockwise. If the vehicle is equipped with central door locking, the tail gate can be locked without a key. Push the front portion of the central door locking switch after closing the tail gate. If the tail gate is open when the front portion of the central door locking switch is pushed, the tail gate will be locked when it is fully closed.