2007 Hyundai Accent Owner's Manual - Page 196

2007 Hyundai Accent Manual

Page 196 highlights

WHAT TO DO IN AN EMERGENCY 3 9 D060D01A-AAT D060E01A-AAT D060F02E-AAT 3. Loosen Wheel Nuts 4. Put the Jack in Place 5. Raising the Car Wrench bar D060D01MC Wheel nut wrench 1JBA6025 D060F01MC The wheel nuts should be loosened slightly before raising the car. To loosen the nuts, turn the wrench handle counterclockwise. When doing this, be sure that the socket is seated completely over the nut so it cannot slip off. For maximum leverage, position the wrench so the handle is to the right as shown in the drawing. Then, while holding the wrench near the end of the handle, pull up on it with steady pressure. Do not remove the nuts at this time. Just loosen them about onehalf turn. The base of the jack should be placed on firm, level ground. The jack should be positioned as shown in the drawing. After inserting a wrench bar into the wheel nut wrench, install the wrench bar into the jack as shown in the drawing. To raise the vehicle, turn the wheel nut wrench clockwise. As the jack begins to raise the vehicle, double check that it is properly positioned and will not slip. If the jack is on soft ground or sand, place a board, brick, flat stone or other object under the base of the jack to keep it from sinking.

We apologize, but we cannot currently deliver this PDF manual by request of the manufacturer.

We apologize for any inconveniece.